Reference Guide
Output
racadm racreset
RAC reset operation initiated successfully. It may take up to a minute for
the RAC to come online again.
Example
• To reset CMC.
racadm racreset
• To reset server 1
racadm racreset -m server-1
• To reset servers 1 and 3
racadm racreset -m server-1 -m server-3
racresetcfg
Description
Deletes your current CMC conguration and resets CMC to the factory default settings. After reset, the
default name and password are root and calvin, respectively, and the IP address is 192.168.0.120.
If you run racresetcfg from a network client (for example, a supported web browser, Telnet or SSH, or
Remote RACADM), use the default IP address. The racresetcfg subcommand does not reset the
cfgDNSRacName object.
To run this subcommand, you must have the Chassis Administrator privilege.
NOTE: Certain rmware processes must be stopped and restarted to complete the reset to defaults.
CMC becomes unresponsive for about 30 seconds while this operation completes.
NOTE: There is a 100 percent fan request when the command is issued against the servers.
Synopsis
• racadm racresetcfg
RAC reset operation initiated successfully. It may take several minutes
for the RAC to come online again.
• racadm racresetcfg [-m <module>] [-c <feature>]
Input
• -m <module> — Species the device to reset the conguration on <module>. <module> must be one
of the following values:
– chassis — Default state if -m is not specied
– server–<n> — where n=1–16
– server–<nx> — where n=1–8; x=a, b, c, d (lower case)
– kvm
• -c <feature> — Must be one of the following values:
– ad — Reset Active Directory properties to default (default is disabled).
– pcap — Reset Power Cap to default.
– flex — Reset exaddress properties to default (default is disabled).
– dpse — Reset Dynamic Power Supply Engagement to default (default is disabled).
NOTE: FlexAddress or FlexAddressPlus will be set to enabled on running racadm racresetcfg
(default is enabled without –c option). The server must be turned o prior to running this command
to change the slot state.
NOTE: -c option is valid with <module = chassis> only.
NOTE: If chassis is the target of racresetcfg, CMC resets after the operation.
Example
• Reset the KVM conguration on CMC.
racadm racresetcfg -m kvm
62