Reference Guide

NOTE: To deactivate FlexAddress features, the chassis must be turned o.
Synopsis
• racadm feature -s
• racadm feature -d -c <featurename>
• racadm feature -r -c ExtendedStorage
Input
-s
–Displays the status of active features.
-d
–Deactivates feature specied in -c option.
NOTE: When the FlexAddress and FlexAddressPlus feature are active, deactivating one of them
results in deactivation of the other feature also.
-r
—Reformats damaged or unformatted extended storage media.
CAUTION: Using the -r switch deactivates the extended storage feature, if active; reformats the SD
card in the active CMC card slot; and may Restart the active CMC.
-c
— <featurename> — must be one of the following:
• flexAddress
• flexAddressPlus
• ExtendedStorage (with -d, or -r)
NOTE: The —a option is not supported for CMC 5.0.
Example
• Display the current status of all chassis features:
racadm feature -s
• Deactivate the FlexAddressPlus feature on the chassis:
racadm feature -d -c FlexAddressPlus
featurecard
Description
Veries proper SD card installation and displays the SD card status.
To use this subcommand, you must have the Chassis Conguration Administrator privilege.
Synopsis
racadm featurecard -s
Input
-s — Lists active SD card features and SD card status.
Output
• No feature card inserted — Action: To verify that the SD card was properly inserted, check the
CMC. In a redundant CMC conguration, make sure the CMC with the SD feature card installed is the
active CMC and not the standby CMC.
• The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to this chassis
— Action: No action
required.
• No features active on the chassis — Action: Install the SD card into the CMC.
• The feature card inserted is valid and contains the following feature(s)
FlexAddress: The feature card is bound to another chassis, svctag =
ABC1234, SD card SN = 01122334455
Action: Remove the SD card; locate and install the SD card for the current chassis.
23