Owner's Manual

NOTE: Before you update the server component firmware modules listed above, you must update CMC firmware.
NOTE: To update firmware using Lifecycle Controller, iDRAC firmware must be of version 3.2 or greater.
If manually updating firmware using Dell Update Packages (DUPs), the firmware should be updated in the following
order:
1.
BIOS
2.
Lifecycle Controller
3.
iDRAC6/iDRAC7
NOTE: To update iDRAC firmware to 3.0 or greater from an iDRAC version less than 2.3, you must first update the iDRAC
firmware to version 2.3 before updating to version 3.0 or greater.
Notes
While using the command "racadm config -f" with:
• CMC 3.21 or later versions of firmware, make sure that the Remote RACADM client version 6.3.0 or later is installed.
• CMC with an earlier version of 3.21 firmware, make sure that the Remote RACADM client version earlier than 6.3.0 is
installed.
Uninstallation
For information, see the Dell Chassis Management Controller Firmware Version 4.3 User’s Guide.
Limitations
• The remote racadm testfeature command “racadm -r <IP Address> testfeature ...” does not support the -d (debug)
option.
• For Single Sign-On and Smart Card login, the client system must be a part of the Active Directory domain and
Kerberos Realm. On Windows 7, clients under the Local Security Polices, make sure to configure the security
option "Network security: Configure encryption types allowed for Kerberos." This policy setting allows you to set
the encryption types that Kerberos is allowed to use. The DES_CBC_MD5 encryption type must be selected. If this
encryption type is not selected, the encryption type will not be allowed. This setting may affect compatibility with
client computers or services and applications.
• When you add a member chassis to a chassis group using the Multi-Chassis Management feature, you cannot specify
the group members with an IPv6 address.