Reference Guide

Switch-2 Not Present N/A N/A N/A
Switch-3 Not Present N/A N/A N/A
Switch-4 Not Present N/A N/A N/A
Switch-5 Not Present N/A N/A N/A
Switch-6 Not Present N/A N/A N/A
Server-1 Not Present N/A N/A N/A
Server-2 Present OFF OK
Server-3 Present ON OK S YW
Server-4 Present ON OK
Server-5 Present ON OK
Server-6 Present ON OK 1234567
Server-7 Present ON OK
Server-8 Not Present N/A N/A N/A
Server-9 Not Present N/A N/A N/A
Server-10 Extension(2) N/A N/A N/A
Server-11 Not Present N/A N/A N/A
Server-12 Present ON OK
Server-13 Not Present N/A N/A N/A
Server-14 Present ON OK 0000015
Server-15 Present ON OK
Server-16 Present ON OK
KVM Present ON OK
IO-Cable Present ON OK ABC1234
FPC-Cable Present ON OK ABC1234
NOTE: For CMC only, a power state of "Primary" denotes Active CMC.
getniccfg
Description Displays the current NIC settings.
Synopsis
racadm getniccfg
Input
racadm getniccfg
racadm getniccfg –m <module>
where –m must be one of the following values:
• chassis
: default state if -m is not specified
• server-n
: where n = 1 to 16
• server-nx
: where n = 1 to 8; x = a to d (lower case)
• switch-n
: where n = 1 to 6
Example
racadm getniccfg
racadm getniccfg –m <module>
Output
The getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the
output is displayed in the following format:
78