Reference Guide

To use this subcommand with the get and test option, you must have Administrator

privilege.

This subcommand is applicable only for iDRAC.

Synopsis

racadm eventfilters <eventfilters command type>

racadm eventfilters get -c <alert descriptor>

racadm eventfilters set -c <alert descriptor>-a <action>-n

racadm eventfilters set -c <alert descriptor>-a <action>-r

racadm eventfilters test -i <Message ID to test>

NOTE: The general format of an alert descriptor:

idrac.alert.category.[subcategory].[severity]

, where, category is mandatory, but subcategory and severity are optional. A

severity cannot precede a subcategory.

Valid Category values are:

• All

• System

• Storage

• Updates

• Audit

• Config

• Worknotes

Valid Severity values are:

• Critical

• Warning

• Info

Valid examples of alert descriptors are:

• idrac.alert.all

• idrac.alert.audit

• idrac.alert.audit.lic

• idrac.alert.audit.warning

• idrac.alert.audit.lic.critical

Input

• get — Displays the list of eventfilter settings.

• set — Configures the actions and notifications for a given eventfilter

configuration.

• -i — Message ID for which the simulation is needed.

• -c — Alert descriptor of the specific event filter.

• -a — The action that must be invoked when the event occurs. Valid values are

none, powercycle, poweroff, or systemreset.

• -n — The notification to be sent when the event occurs. Valid values are all,

snmp, ipmi, lcd, email, or none. You can append multiple notifications separated

by a comma. You cannot enter the values all or none with other notifications.