Reference Guide

• -u root — Indicates that the < password > is supplied for the root user on the
server or switch. Root is a constant parameter, the only value that is valid
with the ‑u option.
• -m < module > — Specifies the server or switch you want to configure.
Legal values:
– sever-n, where n =1–16
– server-nx where n =1– 8; x = a,b,c,d
– switch-n, where n =1– 6
• -p < password > — Specifies the password for the root user on the server or
switch. For switches, valid passwords are 6-32 ASCII characters in length,
ranging in value between 32 – 125 (decimal). For servers, valid passwords are
1 – 20 ASCII characters in length, ranging in value between 32 – 126
(decimal).
• -s < ipaddress subnet gateway > — Sets the IP address, subnet mask, and
gateway for the specified server, separated by single spaces.
– ipaddress — A string representing a valid IP address. For example,
192.168.0.20.
– subnet — A string representing a valid subnet mask. For example,
255.255.255.0.
– gateway — A string representing a valid gateway address. For
example, 192.168.0.1.
• -d — Enables DHCP for the specified server.
The -s and -d options cannot be used together in the same command.
• -6 — Enables IPv6 auto configuration (when used with -d.) Sets static IPv6
addresses (when used with -s)
• -v SNMPv2 < snmpCommunityString > ro — Specifies the SNMP community
string for switches. Valid community strings are 1-20 characters in length,
with valid ASCII characters in the range [32–125] (decimal). Protocol version
set to SNMPv2. Permission on community string is read-only.
Output None
Example
• racadm deploy -m server-8 -s 192.168.0.20 255.255.255.0 192.168.0.1
The server was deployed successfully.
• racadm deploy -m server-9 -s 192.168.0.11 255.255.255.0 192.168.0.1
ERROR: Server in slot 9 is an extension of the server in slot 1.
The deploy command generates an error when used on the extension slot of
a multi-slot server.
• racadm deploy -m server-1 -u root -p calvin -s -6 2001:DB8::2 64 2001:DB8::1 -
b HDD -o yes
• Set root password, configure static IPV6 address, set first boot device to
HDD, and enable boot once for server-1
• Set root password, configure static IPV6 address, set first boot device to
HDD, and enable boot once for server-1
racadm deploy -m server-1 -u root -p <password>-s
-6 2001:DB8::2 64 2001:DB8::1 -b HDD -o yes
eventfilters
Description
Gets, sets, test the alerts for message ID, and displays the list of event filter settings.
52