Reference Guide

System.Power.PFCEnable (Read or Write)
Description Enables the power factor correction enable.
NOTE:
• This object is supported only for iDRAC on
Rack and Tower servers.
• This object is applicable only if
System.Power.Cap.Enable is set to 1.
Legal Values
• 0 - Disabled
• 1 - Enabled
Write Privilege Configure iDRAC
License Required iDRAC7 Express or iDRAC7 Enterprise
Dependency None
System.Power.RedundancyCapabilities (Read Only)
Description Returns the redundancy capabilities in the form of a
bitmask. This bitmask indicates the values that are set by
cfgSensorRedundancyPolicy.
NOTE: This object is not applicable on iDRAC on
Blade servers.
Legal Values A Bit Mask.
More than 1 bit can be set at a time to indicate multiple
redundancy support.
• 0 - not applicable
• 1 - Non Redundant
• 2 - 1+1 Redundant
• 4 - 2+1 Redundant
• 8 - 2+2 Redundant
• 16 - 3+x Redundant
• 32 - 4+x Redundant
• 64 - 5+x Redundant
Default 0
System.Power.RedundantState (Read Only)
Description
Retrieves the redundancy state for the chassis.
Legal Values
• 0 - None
• 1 - Full
259