Reference Guide

• View the current test trap settings
racadm getconfig -g cfgIpmiPet -i <index>
where < index > is a number from 1 to 4
testalert
Description Tests FQDN supported SNMP trap notifications.
To use this subcommand, you must have Test Alert User Access .
This subcommand is applicable only for iDRAC.
Synopsis
racadm testalert -i <index>
Input -i — Specifies the index of the trap test. index must be an integer from 1 to 8 on iDRAC.
Output
Success: Test trap sent successfully
Failure: Unable to send test trap
Example
• Test a trap with index as 1
racadm testalert -i 1
Test trap sent successfully.
• Test a trap that has not been configured yet
racadm testalert -i 2
ERROR: Trap at specified index is not currently
enabled.
traceroute
Description Traces the network path of routers that the packets take as they are forwarded from your
system to a destination IPv4 address.
To use this subcommand for CMC, you must have Administrator privilege and for iDRAC,
you must have Execute Diagnostic Commands permission.
Synopsis
racadm traceroute <IPv4 address>
racadm traceroute 192.168.0.1
Input
racadm traceroute 192.168.0.1
Output
traceroute to 192.168.0.1 (192.168.0.1), 30 hops
max,
40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms
traceroute6
Description
Traces the network path of routers that the packets take as they are forwarded from
your system to a destination IPv6 address.
136