Quick Reference Guide

testemail
Description Sends a test e-mail from iDRAC to a specified destination. Prior to executing the test e-
mail command, make sure that the SMTP server is configured and the specified index in
the RACADM cfgEmailAlertgroup is enabled and configured properly. See cfgEmailAlert
for more information.
Synopsis
racadm testemail -i <index>
Input -i — Specifies the index of the e-mail alert to test.
Output
Success: Test e-mail sent successfully
Failure: Unable to send test e-mail
Example Commands for the cfgEmailAlert group:
• Enable the alert —
racadm config -g cfgEmailAlert -o
cfgEmailAlertEnable -i 1
1
• Set the destination e-mail address —
racadm config -g cfgEmailAlert -o
cfgEmailAlertAddress -i 1 [e-mail]
m
• Set the custom message that is sent to the destination e-mail address —
racadm config -g cfgEmailAlert -o
cfgEmailAlertCustomMsg -i 1 "This is a test!"
• Make sure that the SMTP IP address is configured properly —
racadm config -g cfgRemoteHosts -o
cfgRhostsSmtpServerIpAddr 192.168.0.152
• View the current e-mail alert settings —
racadm getconfig -g cfgEmailAlert -i <index>
where < index > is a number from 1 to 4.
testfeature
The following tables describe the testfeature subcommand options.
99