Quick Reference Guide

Description Tests LDAP configuration and operation, and reports
success as each stage of the authentication process
proceeds. On successful completion, this command prints
the CMC privileges assumed by the specified < username >.
If a failure occurs, the command terminates with an error
message that displays the required corrective action. Use
the optional -d switch to obtain additional diagnostic
information, as needed.
Synopsis
testfeature -f ldap -u <username> -p
<password>
[-d <diagnostic-message-level>]
testtrap
Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a
specified destination trap listener on the network.
To use this subcommand, you must have Test Alerts permission.
NOTE: For iDRAC only, before you execute the testtrap subcommand, make sure that
the specified index in the RACADM cfgIpmiPet group is configured properly. The
cfgIpmiPet group is applicable only for iDRAC.
NOTE: For CMC only, before you execute the testtrap subcommand, make sure that
the specified index in the RACADM cfgAlerting group is configured properly. The
cfgAlerting group is applicable only for CMC.
Synopsis
racadm testtrap -i <index>
Input -i — Specifies the index of the trap configuration to be used for the test. Valid values are
from 1 to 4.
Example
Commands for the cfgIpmiPet group:
• Enable the alert
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -
i 1
1
• Set the destination e-mail IP address
racadm config -g cfgIpmiPet -o
cfgIpmiPetAlertDestIpAddr -i 1 192.168.0.110
• View the current test trap settings
racadm getconfig -g cfgIpmiPet -i <index
>
where < index > is a number from 1 to 4
traceroute
Description
Traces the network path of routers that packets take as
they are forwarded from your system to a destination IPv4
address.
102