Manualshelf

Owner's Manual

ManualsBrandsDell ManualsSoftwareDell Chassis Management Controller Version 4.1
411412413414415416417418419420
Troubleshooting and Recovery 415
Telnet RACDUMP
SSH/Telnet RACDUMP is used to refer to the RACDUMP command usage
from a SSH or Telnet prompt.
For more information on RACDUMP instruction, see the RACADM
Command Line Reference Guide for iDRAC and CMC on
support.dell.com/manuals.
Configuring LEDs to Identify Components on the Chassis
You can set component LEDs for all or individual components (chassis,
servers, and IOMs) to blink as a means of identifying the component on the
chassis.
NOTE: To blink or unblink the chassis, I/O modules or the CMC, you must have
Debug Administrator privilege on CMC. To enable the servers to blink or unblink,
you must have Server Administrator or Debug Administrator privilege on CMC.
Using the Web Interface
To enable blinking for one, multiple, or all component LEDs:
1
Log in to the CMC Web interface.
2
Click
Chassis
in the system tree.
3
Click the
Troubleshooting
tab.
4
Click the
Identify
subtab. The
Identify
page displays, featuring a list of all
components on the chassis.
5
To enable blinking for a component LED, check the box beside the device
name and then click
Blink
.
6
To disable blinking for a component LED, check the box beside the device
name and then click
UnBlink
.