Owner's Manual

408 I/O Fabric Management
Configuring Network Settings for an Individual IOM
The I/O Modules Setup page allows you to specify the network settings
for the interface used to manage the IOM. For Ethernet switches, the
out-of-band management port (IP address) is what is configured. The in-band
management port (that is, VLAN1) is not configured using this interface.
NOTE: To change settings on the I/O Modules Configuration page, you must have
Fabric A Administrator privileges to configure IOMs in Group A; Fabric B
Administrator privileges to configure IOMs in Group B; or Fabric C Administrator
privileges to configure IOMs in Group C.
NOTE: For Ethernet switches, the in-band (VLAN1) and out-of-band
management IP addresses cannot be the same or on the same network; this results
in the out-of-band IP address not being set. Refer to the IOM documentation for the
default in-band management IP address.
NOTE: Only those IOMs present in the chassis are displayed.
NOTE: Do not configure I/O module network settings for Ethernet pass-through and
Infiniband switches.
MAC Address Displays the MAC address for the IOM. The MAC address is a
unique address assigned to a device by the hardware vendor as a
means for identification.
NOTE: Pass-throughs do not have MAC addresses. Only switches
have MAC addresses.
Role Displays the I/O module stacking membership when modules are
linked together:
• Member - the module is part of a stack set
•
Master - the module is a primary access point.
Table 11-2. I/O Module Health Status Information (continued)
Item Description