Owner's Manual

358 Power Management
Setting the Power Budget
NOTE: To perform power management actions, you must have Chassis
Configuration Administrator privilege.
Using the Web Interface
To set the power budget using the CMC Web interface:
1
Log in to the CMC Web interface.
2 Click Chassis Overview in the system tree. The Chassis Health page
appears.
3 Click the Power tab. The Power Consumption Status page appears.
4 Click the Configuration subtab.
The
Budget/Redundancy Configuration page appears.
5 Type a budget value of up to 16685 watts in the System Input Power Cap
text field.
NOTE: The power budget is limited to a maximum of which ever set of three
PSUs that is the weakest. If you attempt to set an AC power budget value that
exceeds this value, CMC displays a failure message.
NOTE: When value changes are specified in watts, the submitted value
exactly reflects what is actually applied. However, when the changes are
submitted in either of the BTU/h or percent units, the submitted value may
not exactly reflect what is actually applied. This is because these units are
converted to watts and then applied; and the conversion is susceptible to
some rounding error.
6 Click Apply to save your changes.