Owner's Manual

Power Management 345
Table 9-9. Real-Time Energy Statistics Status
Item Description
System Energy
Consumption
Displays the current cumulative energy consumption for all
modules in the chassis measured from the input side of the
power supplies. The value is displayed in KWh and it is a
cumulative value.
System Energy
Consumption Start
Time
Displays the date and time recorded when the system energy
consumption value was last cleared, and the new
measurement cycle began. The timestamp is displayed in the
format hh:mm:ss MM/DD/YYYY, where hh is hours (0-24),
mm is minutes (00-60), ss is seconds (00-60), MM is the
month (1-12), DD is the day (1-31), and YYYY is the year.
This value is reset with the Reset Energy Statistics button,
but persists through a CMC reset or fail over operation.
System Energy
Consumption
Timestamp
Displays the date and time when the system energy
consumption was calculated for display. The timestamp is
displayed in the format hh:mm:ss MM/DD/YYYY, where hh
is hours (0-24), mm is minutes (00-60), ss is seconds (00-60),
MM is the month (1-12), DD is the day (1-31), and YYYY is
the year.
Table 9-10. System Power Status
Item Description
Overall Power Health Indicates the health status of the chassis’ power subsystem.:
•Green Check Icon for OK
• Yellow Exclamation Icon for
Non-Critical
•Red X Icon for
Critical
System Power Status Displays the power status (On, Off, Powering On, Powering
Off) of the chassis.
Redundancy Displays the redundancy status. Valid values are:
No — PSUs are not redundant
Yes — full redundancy in effect