Owner's Manual

252 Using FlexAddress
Verifying FlexAddress Activation
To ensure proper activation of FlexAddress, RACADM commands can be
used to verify the SD feature card and FlexAddress activation.
Use the following RACADM command to verify the SD feature card and its
status:
racadm featurecard -s
Use the following RACADM command to display all activated features
on the chassis:
racadm feature -s
Table 6-1. Status Messages Returned by featurecard -s Command
Status Message Actions
No feature card inserted. Check CMC to verify that the SD card was
properly inserted. In a redundant
CMC configuration, ensure that the CMC
with the SD feature card installed is the active
CMC and not the standby CMC.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to this chassis.
No action required.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is
bound to another chassis,
svctag = ABC1234, SD card
SN = 01122334455
Remove the SD card; locate and install
the SD card for the current chassis.
The feature card inserted is valid and
contains the following feature(s)
FlexAddress: The feature card is not
bound to any chassis.
The feature card can be moved to another
chassis or can be reactivated on the current
chassis.To reactivate on the current chassis,
enter
racadm racreset until the
CMC module with the feature card installed
becomes active.