Owner's Manual

Using the CMC Web Interface 239
The status page presents the following information:
Table 5-63. Status Page Information
FlexAddress
Enabled
Displays whether the FlexAddress feature is active or not active
for the particular slot.
Current State Displays the current FlexAddress configuration:
• Chassis-Assigned - selected slot address is chassis assigned using
the FlexAddress. The slot-based WWN/MAC addresses remain
the same even if a new server is installed.
•
Server-Assigned - server uses the server-assigned address or the
default address embedded into the controller hardware.
Power State Displays the current power status of the servers. Values are: On,
Powering On, Powering Off, Off, and N/A (if a server is not
present).
Health OK Indicates that FlexAddress is present
and providing status to CMC. In the
event of a communication failure
between CMC and FlexAddress, CMC
cannot obtain or display health status
for FlexAddress.
Informational Displays information about FlexAddress
when no change in health status
(OK, Warning, Critical) has occurred.
Warning Indicates that only warning alerts have
been issued, and corrective action must
be taken. If corrective actions are not
taken, then critical failures that can
affect the integrity of the server could
occur.
Critical Indicates that at least one Failure alert
has been issued. Critical status
represents a system failure on the server,
and corrective action must be taken
immediately.
No Value When FlexAddress is absent, health
information is not provided.
iDRAC firmware Displays the iDRAC version currently installed on the server.