Owner's Manual

236 Using the CMC Web Interface
Completion Status and Troubleshooting
To check the completion status of a requested BIOS profile applied:
1
Capture the job id (JID) of the submitted job of interest from the Recent
Profile Log
table on the server cloning main page.
2 Look up the same JID in the Jobs table on the Lifecycle Controller Jobs
page (
Server Overview  Troubleshooting  Lifecycle Controller Jobs ).
FlexAddress
This section describes the FlexAddress Web interface screens. FlexAddress is
an optional upgrade that allows server modules to replace the factory-
assigned WWN/MAC ID with a WWN/MAC ID provided by the chassis.
NOTE: You must purchase and install the FlexAddress upgrade to have access to
the configuration screens. If the upgrade has not been purchased and installed, the
following text is displayed on the Web interface:
Optional feature not installed. See the Dell
Chassis Management Controller Users Guide for
information on the chassis-based WWN and MAC
address administration feature.
To purchase this feature, please contact Dell at
www.dell.com.
Viewing FlexAddress Status
You can use the Web interface to view FlexAddress status information. You
can view status information for the entire chassis or for an individual server.
The information displayed includes:
• Fabric configuration.
•FlexAddress active/not active.
• Slot number and name.
• Chassis-assigned and server-assigned addresses.
• Addresses in use.
NOTE: You can also view FlexAddress status using the command line interface.
For more command information, see "Using FlexAddress" on page 249.