Owner's Manual

230 Using the CMC Web Interface
6 To deploy the setting to iDRAC, click Apply iDRAC Network Settings
button. If you made changes to the QuickDeploy settings, they are
also saved.
7 To restore the iDRAC Network settings to the current values for each
installed server, and update the QuickDeploy table to the last saved
QuickDeploy settings click
Refresh .
NOTE: Clicking Refresh button deletes all iDRAC QuickDeploy and iDRAC
Network configuration settings that have not been saved.
IPMI over LAN Enables (checked) or disables (unchecked) the IPMI LAN
channel. LAN must be enabled to set this field.
IP Address The static IPv4 or IPv6 address assigned to the iDRAC
located in this slot.
Subnet Mask Specifies the subnet mask assigned to the iDRAC installed
in this slot.
Gateway Specifies the default gateway assigned to the iDRAC which
is installed in this slot.
Enable IPv4 Enables the iDRAC in the slot to use the IPv4 protocol on
the network. You must select the Enable LAN option for
this option to be active. Default setting is enabled.
Enable IPv6 Enables the iDRAC in the slot to use the IPv6 protocol on
the network. You must select the Enable LAN option and
clear the Autoconfiguration option for this option to be
active. Default setting is disabled.
NOTE: This option is available only if the server is
IPv6 capable.
Autoconfiguration Enables the iDRAC to obtain IPv6 settings (Address and
prefix length) from a DHCPv6 server and also enables
stateless address auto configuration.
NOTE: This option is available only if the server is
IPv6 capable.
Prefix Length Specifies the length, in bits, of the IPv6 subnet to which
this iDRAC belongs.
Table 5-62. iDRAC Network Settings (continued)
Setting Description