Owner's Manual

Using the CMC Web Interface 229
To enable and set the iDRAC Network Settings:
1
Log in to the CMC Web interface.
2 Select Server Overview in the system tree.
3 Click the Setup tab.
The
Deploy iDRAC page appears.
4 Select the check box for QuickDeploy Enabled to enable the
QuickDeploy settings.
5 Set the remaining iDRAC Network Settings accordingly.
Table 5-62. iDRAC Network Settings
Setting Description
Slot Displays the slot occupied by the server in the chassis.
Slot numbers are sequential IDs, from 1 to 16 (there are 16
slots available on the chassis), that help identify the
location of the server in the chassis.
NOTE: When there are fewer than 16 servers occupying
slots, only those slots populated by servers are displayed.
Name Displays the server name of the server in each slot.
By default, the slots are named SLOT-01 to SLOT-16.
NOTE: The slot name cannot be blank or NULL.
Enable LAN Enables (checked) or disables (unchecked)
the LAN channel.
NOTE: When LAN is not selected (disabled), all other network
configuration settings, (IPMI over LAN, DHCP, IP Address
Subnet Mask and Gateway) are not used. These fields are not
accessible.
Change Root Password Enables (when checked) the ability to change the password
of the iDRAC root user. The iDRAC Root Password and
Confirm iDRAC Root Password fields must be provided
for this operation to be successful.
DHCP If selected DHCP is used to acquire the iDRAC IP address,
subnet mask and default gateway, otherwise the values
defined in the iDRAC network configuration fields are
used. LAN must be enabled to set this field