Owner's Manual

228 Using the CMC Web Interface
5 To save the selections click the Save QuickDeploy Settings button. If you
made changes to the iDRAC network setting, click the
Apply iDRAC
Network Settings
button to deploy the settings to the iDRAC.
6 To update the table to the last saved QuickDeploy settings, and restore the
iDRAC Network settings to the current values for each installed server,
click
Refresh .
NOTE: Clicking the Refresh button deletes all iDRAC QuickDeploy and iDRAC
Network configuration settings that have not been saved.
The QuickDeploy feature only executes when it is enabled, and a server is
inserted in the chassis. If Set iDRAC Root Password on Server Insertion and
QuickDeploy Enabled are checked, the user is prompted using the LCD
interface to allow or not allow the password change. If there are network
configuration settings that differ from the current iDRAC settings, the user is
prompted to either accept or not accept the changes.
NOTE: When there is a LAN or IPMI over LAN difference, the user is prompted to
accept the QuickDeploy IP address setting. If the difference is the DHCP setting,
the user is prompted to accept the DHCP QuickDeploy setting.
To copy the QuickDeploy settings into the iDRAC Network Settings section,
click Auto-Populate Using QuickDeploy Settings. The QuickDeploy network
configurations settings are copied into the corresponding fields in the iDRAC
Network Configuration Settings table.
NOTE: Changes made to QuickDeploy fields are immediate, but changes made to
one or more iDRAC server network configuration settings may require a couple of
minutes to propagate from CMC to iDRAC. Pressing the Refresh button too soon
may display only partially correct data for one or more iDRAC servers.
iDRAC Network Settings
The iDRAC Network Settings section of the Deploy iDRAC page contains a
table listing all installed server’s iDRAC IPv4 and IPv6 network configuration
settings. Using this table you can configure the iDRAC network
configurations settings for each installed server. The initial values displayed
for each of the fields are the current values read from the iDRAC. Changing a
field and clicking Apply iDRAC Network Settings saves the changed field to
the iDRAC.