Owner's Manual

Using the CMC Web Interface 151
For additional instructions on viewing iKVM status and setting properties for
the iKVM, see:
• "Viewing the iKVM Status and Properties" on page 390
• "Enabling or Disabling the Front Panel" on page 389
• "Enabling the Dell CMC Console Through iKVM" on page 390
• "Updating the iKVM Firmware" on page 392
For more information about iKVM, see "Using the iKVM Module" on
page 369.
Viewing the Health Status of the PSUs
The health status of the PSUs associated with the chassis can be viewed in
two ways: from the Chassis Component Summary section on the Chassis
Health page or the Power Supply Status page. The Chassis Health page
provides a graphical overview of all PSUs installed in the chassis.
To view health status for all PSUs using Chassis Graphics:
1
Log in to the CMC Web interface.
The
Chassis Health page is displayed. The lower section of Chassis
Graphics
depicts the rear view of the chassis and contains the health
status of all PSUs. PSU health status is indicated by the overlay of
the PSU subgraphic:
• No overlay - PSU is present, powered on and communicating with
CMC; there is no indication of an adverse condition.
• Amber caution sign - indicates that only warning alerts have been
issued and that corrective action must be taken.
• Red X - indicates at least one failure condition is present. This means
that CMC can still communicate with the PSU and that the health
status is reported as critical.
• Grayed Out - indicates that the PSU is present and not powered on. It
is not communicating with CMC and there is no indication of an
adverse condition.