Owner's Manual

140 Using the CMC Web Interface
To set the first boot device for some or all servers in the chassis:
1
Log in to the CMC Web interface.
2 Click Server Overview in the system tree and then click Setup  First
Boot Device.
A list of servers is displayed.
3 Select the boot device you want to use for each server from the list box.
4 If you want the server to boot from the selected device every time it boots,
clear the
Boot Once check box for the server.
If you want the server to boot from the selected device only on the next
boot cycle, select the
Boot Once check box for the server and click Apply .
Viewing the Health Status of an Individual Server
The health status for an individual server can be viewed in two ways—
from the Chassis Graphics section on the Chassis Health page or the
Server Status page.
The Chassis Health page provides a graphical overview of an individual server
installed in the chassis.
To view health status for individual servers using Chassis Graphics:
1
Log in to the CMC Web interface.
The
Chassis Health page is displayed. The top section of Chassis
Graphics
depicts the front view of the chassis and contains the health
status for individual servers. Server health status is indicated by the overlay
of the server subgraphic:
• No overlay - indicates that the server is present, powered on and
communicating with the CMC; there is no indication of an adverse
condition.
• Amber caution sign - indicates that only warning alerts have been
issued and that corrective action must be taken.