Owner's Manual

118 Using the CMC Web Interface
7 Optionally, select Sync New Member with Leader Properties to push
leader properties to the member. For more information, see the subsection
"Synchronizing a New Member With Leader Chassis Properties" on
page 120.
8 Select the Apply button.
9 Repeat step 4 through step 8 to add a maximum of eight members.
The new members’ Chassis Names appear in the
Members dialog box.
The status of the new member is displayed by selecting the Group in the tree.
Details are available by clicking on the chassis image or the details button.
NOTE: The credentials entered for a member are passed securely to the member
chassis, to establish a trust relationship between the member and lead chassis. The
credentials are not persisted on either chassis, and are never exchanged again
after the initial trust relationship is established.
Removing a Member from the Leader
You can remove a member from the group from the lead chassis. To remove a
member:
1
Login with chassis administrator privileges to the leader chassis.
2 Select the Lead chassis in the tree.
3 Click Setup  Group Administration .
4 From the Remove Members list, select the member’s name or names to be
deleted, and then click
Apply .
The lead chassis then communicates to the member or members, if more
than one is selected, that it has been removed from the group. The member
name is removed from the dialog box. The member chassis may not receive
the message, if a network issue prevents contact between the leader and the
member. In this case, disable the member from the member chassis to
complete the removal. For more information, see the sub-section "Disabling
an Individual Member at the Member Chassis" on page 119.