Owner's Manual

114 Using the CMC Web Interface
To set the chassis location and chassis name:
1
Log in to the CMC Web interface.
The
Chassis Health page is displayed.
2 Click the Setup tab.
The
General Chassis Settings page is displayed.
3 Type the location properties in the Data Center , Aisle , Rack , and Rack
Slot
fields.
NOTE: The Chassis Location field is optional. It is recommended to use the
Data Center, Aisle, Rack, and Rack Slot fields to indicate the physical location
of the chassis.
4 Type the new name in the Chassis Name field, and then click Apply .
Setting the Date and Time on CMC
You can set the date and time manually, or you can synchronize the date and
time with a Network Time Protocol (NTP) server. To set the date and time on
CMC:
1
Log in to the CMC Web interface.
The
Chassis Health page is displayed.
2 Click the Setup tab.
The
General Chassis Settings page is displayed.
3 Click the Date/Time subtab.
The
Date/Time page is displayed.
4 To synchronize the date and time with a Network Time Protocol (NTP)
server, check
Enable NTP and specify up to three NTP servers.
5 To set the date and time manually, uncheck Enable NTP and edit the
Date and Time fields, select the Time Zone from the drop-down menu,
and then click
Apply .
To set the date and time using the command line interface, see the config
command and cfgRemoteHosts database property group sections in the
RACADM Command Line Reference Guide for iDRAC7 and CMC.