Owner's Manual

- BIOS
- Lifecycle Controller
- iDRAC6
NOTE: Before you update the server component firmware modules listed above, you must update CMC
firmware.
NOTE: To update firmware using Lifecycle Controller, iDRAC firmware must be of version 2.3 or greater.
If manually updating firmware using Dell Update Packages (DUPs), the firmware should be updated in the
following order:
- BIOS
- Lifecycle Controller
- iDRAC6
NOTE: To update iDRAC firmware to 3.0 or greater from an iDRAC version less than 2.3, you must first
update the iDRAC firmware to version 2.3 before updating to version 3.0 or greater.
Open Issues and Resolutions
Fixed Issues/def
 Versions 6.0 and 7.0 of Mozilla Firefox Web Browser do not support IPv6 addresses.
You must use URLs that contain a registered hostname to access a CMC or an iDRAC Server that has
an IPv6 address. A CMC or an iDRAC Server that also has an IPv4 address is supported.
 Non-English versions of the Online Help for power configuration pages incorrectly state that the
required privilege for changing power configuration settings is "Chassis Control Administrator."
The correct privilege is "Chassis Configuration Administrator."
 While using the command "racadm config -f" with:
- CMC 3.21 or later versions of the firmware, make sure that the Remote RACADM client version
6.3.0 or later is installed.
- CMC with an earlier version of 3.21 firmware, make sure that the Remote RACADM client
version earlier than 6.3.0 is installed.
 The Remote RACADM testfeature command
(racadm -r <IP Address> testfeature ...) does not support the -d (debug) option.
 For Single Sign-On and Smart Card login, the client system must be a part of the Active Directory
domain and Kerberos Realm. On Windows 7, clients under the Local Security Policies must make
sure to configure the security option "Network security: Configure encryption types allowed for
Kerberos." This policy setting allows you to set the encryption types that Kerberos is allowed to use.
The DES_CBC_MD5 encryption type must be selected. If this encryption type is not selected, the
encryption type will not be allowed. This setting may affect compatibility with client computers or
services and applications.