Manualshelf

Owner's Manual

ManualsBrandsDell ManualsSoftwareDell Chassis Management Controller Version 4.0
411412413414415416417418419420
Troubleshooting and Recovery 413
Telnet RACDUMP
SSH/Telnet RACDUMP is used to refer to the RACDUMP command usage
from a SSH or Telnet prompt.
For more information on RACDUMP instruction, see the RACADM
Command Line Reference Guide for iDRAC and CMC on
support.dell.com/manuals.
Configuring LEDs to Identify Components on the Chassis
You can set component LEDs for all or individual components (chassis,
servers, and IOMs) to blink as a means of identifying the component on the
chassis.
NOTE: To modify these settings, you must have Chassis Configuration
Administrator privilege.
Using the Web Interface
To enable blinking for one, multiple, or all component LEDs:
1
Log in to the CMC Web interface.
2
Click
Chassis
in the system tree.
3
Click the
Troubleshooting
tab.
4
Click the
Identify
subtab. The
Identify
page displays, featuring a list of all
components on the chassis.
5
To enable blinking for a component LED, check the box beside the device
name and then click
Blink
.
6
To disable blinking for a component LED, check the box beside the device
name and then click
UnBlink
.