Owner's Manual

Using the iKVM Module 381
Removing Password Protection From Your Console
To remove password protection from your console:
1
From the Main dialog box, click Setup and then Security .
2 In the Security dialog box, single-click and press <Enter>, or double-click
in the
New field.
3 Leaving the New field empty, press <Enter>.
4 Single-click and press <Enter>, or double-click in the Repeat field.
5 Leaving the Repeat field empty, press <Enter>.
6 Click OK if you only want to eliminate your password.
Enabling Screen Saver Mode With No Password Protection
NOTE: If your console is password protected, you must first remove password
protection. Follow the steps in the previous procedure before following
the steps below.
To enable Screen Saver mode without password protection:
1
Select Enable Screen Saver .
2 Type the number of minutes (1 through 99) that you want to delay
activation of the screen saver.
3 Select Energy if your monitor is ENERGY STAR compliant; otherwise
select
Screen .
CAUTION: Monitor damage may result from the use of Energy mode with
monitors not compliant with Energy Star.
4 Optional: To activate the screen saver test, click Test . The Screen Saver
Test
dialog box displays. Click OK to start the test.
The test takes 10 seconds. When it concludes, you are returned to the
Security dialog box.
NOTE: Enabling screen saver mode disconnects the user from a server;
no server is selected. The status flag displays Free.