Owner's Manual

264 Using FlexAddress
documentation with only those rights set forth herein.
Contractor/manufacturer is Dell Products, L.P., One Dell Way, Round Rock,
Texas 78682.
GENERAL
This license is effective until terminated. It terminates upon the conditions
set forth above or if you fail to comply with any of its terms.
Upon termination, you agree that the Software and accompanying materials,
and all copies thereof, is destroyed. This agreement is governed by the laws of
the State of Texas. Each provision of this agreement is severable. If a
provision is found to be unenforceable, this finding does not affect the
enforceability of the remaining provisions, terms, or conditions of this
agreement. This agreement is binding on successors and assigns. Dell agrees
and you agree to waive, to the maximum extent permitted by law, any right to
a jury trial with respect to the Software or this agreement. Because this waiver
may not be effective in some jurisdictions, this waiver may not apply to you.
You acknowledge that you have read this agreement, that you understand it,
that you agree to be bound by its terms, and that this is the complete and
exclusive statement of the agreement between you and Dell regarding the
Software.
Frequently Asked Questions
Table 6-3 lists the frequently asked questions for FlexaddressPlus feature.
.
Table 6-3. FlexaddressPlus
Question Answer
After disabling only the
FlexAddressPlus feature (leaving
FlexAddress still activated), why
does the racadm
setflexaddr command on
the (still-active) CMC fail?
If the CMC subsequently becomes active, with the
FlexAddressPlus feature card still in its cardslot,
the FlexAddressPlus feature gets re-activated, and
slot/fabric flexaddress configuration changes can
resume.