Owner's Manual

Using FlexAddress 251
The command returns the following status message:
Feature = FlexAddress
Date Activated = 8 April 2008 - 10:39:40
Feature installed from SD-card SN = 01122334455
If there are no active features on the chassis, the command returns a message:
racadm feature -s
No features active on the chassis.
Dell Feature Cards may contain more than one feature. Once any feature
included on a Dell Feature Card has been activated on a chassis, any other
features that may be included on that Dell Feature Card cannot be activated
on a different chassis. In this case, the racadm feature -s command displays
the following message for the affected features:
ERROR: One or more features on the SD card are active
on another chassis.
For further information on the RACADM commands, see the feature
and featurecard command sections of the RACADM Command Line
Reference Guide for iDRAC6 and CMC.
Deactivating FlexAddress
The FlexAddress feature can be deactivated and the SD card returned to a
pre-installation state using a RACADM command. There is no deactivation
function within the Web interface. Deactivation returns the SD card to
its original state where it can be installed and activated on a different chassis.
NOTE: The SD card must be physically installed in CMC, and the chassis must be
powered-down before executing the deactivation command.
If you execute the deactivation command with no card installed, or with a
card from a different chassis installed, the feature is deactivated and no
change is made to the card.