Owner's Manual

Using the CMC Web Interface 239
Chassis-Level Fabric and Slot FlexAddress Configuration
At the chassis level, you can enable or disable the FlexAddress feature for
fabrics and slots. FlexAddress is enabled on a per-fabric basis and then slots
are selected for participation in the feature. Both fabrics and slots must be
enabled to successfully configure FlexAddress.
Perform the following steps to enable or disable fabrics and slots to use the
FlexAddress feature:
1
Log on to the Web interface (see "Accessing the CMC Web Interface" on
page 109).
2 Click Server Overview in the system tree.
3 Click the Setup tab  FlexAddress subtab. The Deploy FlexAddress page
is displayed.
4 The Select Fabrics for Chassis-Assigned WWN/MACs displays a check
box for
Fabric A , Fabric B, Fabric C , and iDRAC.
5 Click the check box for each fabric you want to enable FlexAddress on.
To disable a fabric, click the check box to clear the selection.
NOTE: If no fabrics are selected, FlexAddress is not enabled for the selected
slots.
The Select Slots for Chassis-Assigned WWN/MACs page displays an
Enabled check box for each slot in the chassis (1 - 16).
6 Click the Enabled check box for each slot you want to enable FlexAddress
on. If you want to select all slots, use the
Select/Deselect All check box.
To disable a slot, click the
Enabled check box to clear the selection.
NOTE: If a server is present in the slot, it needs to be powered off before
the FlexAddress feature can be enabled on that slot.
NOTE: If no slots are selected, FlexAddress is not enabled for the selected fabrics.
7 Click Apply to save the changes . For additional information, click Help .