Owner's Manual

Using the CMC Web Interface 235
Viewing Chassis FlexAddress Status
FlexAddress status information can be displayed for the entire chassis.
The status information includes whether the feature is active and an overview
of the FlexAddress status for each server.
To view whether FlexAddress is active for the chassis:
1
Log in to the Web interface (see "Accessing the CMC Web Interface" on
page 109).
2 Click Chassis Overview in the system tree.
3 Click the Setup tab. The General Setup page appears. The FlexAddress
entry has a value of
Active or Not Active ; a value of active means that the
feature is installed on the chassis. A value of not active means that the
feature is not installed and not in use on the chassis.
To display a FlexAddress status overview for each server module:
1
Log in to the Web interface ("Accessing the CMC Web Interface" on
page 109).
2 Click Server Overview  Properties  WWN/MAC .
3 The FlexAddress Summary page is displayed. This page allows you to view
the WWN configuration and MAC addresses for all slots in the chassis.
The status page presents the following information:
Fabric
Configuration
Fabric A, Fabric B, and Fabric C display the type of the
Input/Output fabric installed.
iDRAC displays the server management MAC address.
NOTE: If Fabric A is enabled, unpopulated slots display chassis-
assigned MAC addresses for Fabric A and MAC or WWNs for Fabrics
B and C if they are in use by populated slots.