Owner's Manual

Using the CMC Web Interface 155
Configuring CMC Network Properties
NOTE: Network configuration changes can result in the loss of connectivity on
current network login.
Setting Up Initial Access to CMC
Before you can begin configuring CMC, you must first configure the CMC
network settings to allow the CMC to be managed remotely. This initial
configuration assigns the TCP/IP networking parameters that enable access
to CMC.
NOTE: You must have Chassis Configuration Administrator privilege to set up CMC
network settings.
1 Log in to the Web interface.
2 Select Chassis Overview in the system tree.
3 Click the Network tab.
The
Network Configuration page is displayed.
4 Enable or disable DHCP for CMC by selecting or clearing the Use DHCP
(For CMC Network Interface IP Address)
check box.
5 If you disabled DHCP, type the IP address, gateway, and subnet mask.
6 Click Apply Changes at the bottom of the page.