Owner's Manual

104 Using the RACADM Command Line Interface

This file is updated as follows:

# Object Group "cfgLanNetworking"

[cfgLanNetworking]

cfgNicIpAddress=10.35.9.143

# comment, the rest of this line is ignored

cfgNicGateway=10.35.9.1

The command racadm config -f <myfile>.cfg parses the file and

identifies any errors by line number. A correct file updates the proper entries.

Additionally, you can use the same getconfig command from the previous

example to confirm the update.

Use this file to download company-wide changes or to configure new systems

over the network with the command, racadm getconfig -f

<myfile>.cfg.

NOTE: Anchor is a reserved word and should not be used in the .cfg file.

Using RACADM to Configure Properties on iDRAC

RACADM config/getconfig commands support the -m <module> option

for the following configuration groups:

•cfgLanNetworking

•cfgIPv6LanNetworking

•cfgRacTuning

• cfgRemoteHosts

•cfgSerial

• cfgSessionManagement

NOTE: For more information on the property default values and ranges, see the

Integrated Dell Remote Access Controller 6 (iDRAC6) Enterprise for Blade Servers

User Guide.