Release Notes

Fixes

• Fixed an issue causing internal server error observed while deleting virtual disk.

• Fixed an issue causing FANs are running at 30% PWM across all the interfaces during single-server iDRAC FW update.

• Fixed an issue causing Unable to set ECC value to raid controller using factory command.

• Fixed an issue causing Internal Server Error while checking the chassis logs.

• Fixed an issue causing LCD orientation getting change to Tower mode after firmware downgrade or upgrade.

• Fixed an issue causing discrepancy in IOM health state when there is fabric mismatch error on IOM.

• Fixed an issue causing Last Post Code status for servers in "Boot F1/F2 prompt" state is incomplete in LCD graphics.

Release 3.21

• Fixed an issue causing LCD freeze by implementing watchdog-based recovery mechanism.

• Fixed an issue causing memory leak to improve SNMP performance.

• Fixed an issue causing CMC or chassis to enter failsafe mode due to memory leak.

• Fixed an issue causing CMC becomes unresponsive and loses SSH access.

• Applied Linux kernel patches to address new security vulnerabilities.

Release 3.10

• Fixed an issue causing the static power cap to not be set near chassis lower power bound value.

Release 3.0

• Fixed an issue causing failure of racresetcfg, when the six RSA-4096 or four RSA-2048, and two 2048 DSA SSH public keys are

uploaded to the CMC.

Release 2.23

• Fixed an issue causing CMC changeover when chassis overall health was updated.

Release 2.20

• Fixed an issue causing flash Media Status showing as "Version mismatch" during changeover or upgrade of the CMC.

• Fixed an issue that caused the Server Profile page to hang when a profile is applied to multiple servers.

• Fixed an issue limiting the speed of bNDC ports on some blades to 1 Gb after initial chassis turn on or blade insertion.

Release 2.12

• Fixed an issue causing failure of RAID10 Virtual Disc (VD) with 8, 12 or 16 drives in creating full VD when the span count 2 is selected.

• Fixed an issue with Server/Host operating system (OS) network flap, which occurs occasionally on Modular platforms for a short

duration during CMC initialization.

• Fixed an issue with Server/Host OS network port off, which occurs after CMC is reset on full-height Modular platforms, when the

second network daughter card is not installed.

• Fixed an issue causing the CMC Web GUI to become unresponsive while using Active Directory login with WinRM.

• Fixed an issue causing memory full condition when the internal log files are oversized.

Fixes 11