CLI Guide

Table 53. Details of getpminfo (continued)
Synopsis
racadm getpminfo
Example
racadm getpminfo
[Real-Time Power Statistics]
System Input Power = 600 W
(188 BTU/hr)
Peak System Power = 600 W
(188 BTU/hr
Peak System Power Start Time = 16:02:10
01/16/2008
Peak System Power Timestamp = 06:32:55
01/26/2009
Minimum System Power = 400 W
(177 BTU/hr)
Minimum System Power Start Time = 22:43:21
01/21/2008
Minimum System Power Timestamp = 06:32:55
01/26/2009
System Idle Power = 68 W (188
BTU/hr)
System Potential Power = 68 W (188
BTU/hr)
System Input Current Reading = 31.2 A
[Real-Time Energy Statistics]
System Energy Consumption =
6.4 kWh
System Energy Consumption Start Time =
16:02:10 01/16/2008
System Energy Consumption Timestamp =
16:02:10 01/16/2008
[System Power Status]
Chassis Power State = ON
Overall Power Health = OK
Redundancy = No
[System Power Policy Configuration]
System Input Power Cap =
7928 W (7928 BTU/hr |
10%)
Surplus for Peak Performance =
7000 W (6130 BTU/hr)
Redundancy Policy =
None
Dynamic PSU Engagement Enabled = No
[Power Budgeting]
System Input Max Power
Capacity = 0 W
Input Redundancy
Reserve = 0 W
Input Power Allocated to
Servers = 0 W
Input Power Allocated to Chassis
Infrastructure = 51W
Total Input Power Available for Allocation
= 0 W
Standby Input Power
Capacity = 0 W
RACADM Subcommand Details
57