CLI Guide

Table 140. testfeature -f ldap
Description Tests LDAP configuration and operation, and reports success as
each stage of the authentication process proceeds. After
successful completion, this command prints the CMC privileges
assumed by the specified <username>.
If a failure occurs, the command stops with an error message that
displays the required corrective action. Use the optional -d switch
to obtain additional diagnostic information, as needed.
Synopsis
testfeature -f ldap -u <username> -p
<password>
[-d <diagnostic-message-level>]
testtrap
Table 141. Details of testtrap
Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified
destination trap listener on the network.
To use this subcommand, you must have the Test Alerts privilege.
NOTE: Before you execute the testtrap subcommand, make sure that the specified index
in the RACADM cfgAlerting group is configured properly.
Synopsis
racadm testtrap -i <index>
Input -i — Specifies the index of the trap configuration to be used for the test. Valid values are from 1 to 4.
Example
Commands for the cfgIpmiPet group:
• Enable the alert
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1
• Set the destination e-mail IP address
racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr -i 1
192.168.0.110
• View the current test trap settings
racadm getconfig -g cfgIpmiPet -i <index>
where <index> is a number from 1 to 4.
traceroute
Table 142. Details of traceroute
Description Traces the network path of routers that packets take as they are
forwarded from your system to a destination IPv4 address.
To use this subcommand, you must have the Administrator
privilege.
RACADM Subcommand Details 119