CLI Guide

Table 136. Details of testemail (continued)
• Set the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertAddress -i 1
[e-mail]
• Set the custom message that is sent to the destination e-mail address —
racadm config -g cfgEmailAlert -o cfgEmailAlertCustomMsg -i 1
"This is a test!"
• Make sure that the SMTP IP address is configured properly —
racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr
192.168.0.152
• View the current e-mail alert settings —
racadm getconfig -g cfgEmailAlert -i <index>
where <index> is a number from 1 to 4.
testfeature
The following tables describe the testfeaturesubcommand options.
Table 137. Details of testfeature
Option Description
-f <feature> Specifies the feature name. testfeature supports the following
features:
• ad — Tests Active Directory configuration using simple
authentication (user name and password).
• adkrb — Tests Active Directory configuration using the
Kerberos authentication.
• ldap — Tests LDAP configuration and operation (requires user
name and password).
-u <username> The user name specified in an appropriate format for the selected
authentication method. That is, Active Directory users are specified
as user_name@domain_name.
-p <password> The password for the indicated user account.
-d <bitmask> A bitmask (specified as a hexadecimal value) to select various
diagnostic messaging levels. This option is optional.
NOTE: -d option is not supported with the remote
racadm interface.
Table 138. testfeature -f ad
Description Tests Active Directory configuration using simple authentication
(user name and password). Use the optional -d switch to obtain
additional diagnostic information, as needed.
This subcommand when executed performs the following:
• Checks command syntax.
• Verifies whether the required system resources are available.
• Validates Active Directory configuration.
RACADM Subcommand Details 117