Users Guide

Table 23. : Default Role Group Privileges
Role Group Default Privilege Level Permissions Granted Bit Mask
1 None
• CMC Login User
• Chassis Configuration Administrator
• User Configuration Administrator
• Clear Logs Administrator
• Chassis Control Administrator (Power Commands)
• Server Administrator
• Test Alert User
• Debug Command Administrator
• Fabric A Administrator
0x00000fff
2 None
• CMC Login User
• Clear Logs Administrator
• Chassis Control Administrator (Power Commands)
• Server Administrator
• Test Alert User
• Fabric A Administrator
0x00000ed9
3 None CMC Login User 0x00000001
4 None No assigned permissions 0x00000000
5 None No assigned permissions 0x00000000
NOTE: The Bit Mask values are used only when setting Standard Schema with the RACADM.
NOTE: For more information about user privileges, see Types of Users.
Configuring Standard Schema Active Directory
To configure CMC for an Active Directory login access:
1. On an Active Directory server (domain controller), open Active Directory Users and Computers Snap-in.
2. Using the CMC Web interface or RACADM:
a) Create a group or select an existing group.
b) Configure the role privileges.
3. Add the Active Directory user as a member of the Active Directory group to access CMC.
Configuring Active Directory With Standard Schema Using CMC Web
Interface
NOTE: For information about the various fields, see the
CMC Online Help .
1. In the left pane, go to Chassis Overview, and then click User Authentication > Directory Services. The Directory Services page
is displayed.
2. Select Microsoft Active Directory (Standard Schema). The settings to be configured for standard schema is displayed on the
same page.
3. In the Common Settings section, specify the following:
• Select Enable Active Directory and enter the timeout value for Active Directory in the AD Timeout field.
• To obtain the Active Directory Domain Controllers from a DNS lookup select Look Up Domain Controllers with DNS, and then
select one of the following:
• User Domain from Login — to perform the DNS lookup with the domain name of the login user.
• Specify a Domain — enter the domain name to use for the DNS lookup
• To enable CMC to use the specified Active Directory Domain Controller server addresses, select Specify Domain Controller
Addresses . These server addresses are the addresses of the domain controllers where the user accounts and the role groups are
located.
Configuring User Accounts and Privileges
117