Users Guide
Accessing a Server Using KVM
To map the server to the KVM and enable accessing the server remote console through the KVM interface, you can use the CMC web
interface, RACADM, or the LCD interface.
Mapping a Server to KVM Using CMC Web Interface
Make sure the KVM console is connected to the chassis.
To map a server to a KVM:
1 In the left pane, click Chassis Overview > Front Panel > Setup .
2 On the Front Panel Conguration page, under the KVM Conguration section, from the KVM Mapped list, select the slot that must
be mapped to a KVM, and then click
Apply.
NOTE: The KVM allows mapping to all the server slots. Inserting a full–height or replacing a half–height server with full–height
server does not change the mapping behavior. However, if the KVM is mapped to a lower slot and the slot has a full–height
server, then the KVM is available only through the upper slot. You must remap the KVM to the upper slots.
Mapping the Server to KVM Using LCD
Make sure the KVM console is connected to the chassis.
To map the server to the KVM using the LCD — From the Main Menu screen on the LCD, go to KVM Mapping, select the server that
must be mapped, and then press OK.
Mapping a Server to a DVD Drive
To map the server to the chassis DVD drive:
1 In the left pane, click Chassis Overview > Front Panel > Setup .
2 On the Front Panel Conguration page, under the DVD Drive Conguration section:
From the DVD Mapped drop-down menu, select one of the servers. Select the servers for which chassis DVD drive access is required.
3 Click Apply.
The DVD allows mapping to all the server slots. Inserting a full–height or replacing a half–height server with full–height server does not
change the mapping behavior. However, if the DVD is mapped to a lower slot and the slot has a full–height server, then the DVD is available
only through the upper slot. You must remap the DVD to the upper slots.
42
Installing and Setting Up CMC