Owner's Manual

Troubleshooting and Recovery 427
Resetting Components
The Reset Components page allows users to reset the active CMC, or to
virtually reseat servers causing them to behave as if they were removed and
reinserted. If the chassis has a standby CMC, resetting the active CMC
causes a failover and the standby CMC becomes active.
NOTE: To reset components, you must have Debug Command Administrator
privilege.
To access the Diagnostic Console page:
1
Log in to the CMC Web interface.
2 Click Chassis in the system tree.
3 Click the Troubleshooting tab.
4 Click the Reset Components subtab. The Reset Components page
displays. The
CMC Summary section of the Reset Components page
displays the following information:
Table 12-12. CMC Summary
Attribute Description
Health OK CMC is present and communicating with its
components.
Informational Displays information about CMC when no
change in health status (OK, Warning, Severe)
has occurred.
Warning Warning alerts have been issued, and
corrective action must be taken. If corrective
actions are not taken, critical or severe failures
that can affect the integrity of CMC can occur.
Severe At least one failure alert has been issued.
Severe status represents a CMC system failure,
and corrective action must be taken
immediately.
Date/Time Displays the date and time for the CMC using
the format MM/DD/YYYY, where MM is the
month, DD is the date, and YYYY is the year.