Owner's Manual

Troubleshooting and Recovery 409
a Type a valid e-mail address in an empty Destination Email
Address
field.
b Enter an optional Name . This is the name of the entity receiving the
e-mail. If a name is entered for an invalid e-mail address, it is ignored.
c Click Apply to save your settings.
To send a test e-mail to an e-mail alert destination using the CMC Web
interface:
1
Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Alerts tab. The Chassis Events page appears.
4 Click the Email Alert Settings subtab. The Email Alert Destinations page
displays.
5 Click Send in the Destination Email Address column beside the
destination.
Using RACADM
To send a test e-mail to an e-mail alert destination using RACADM:
1
Open a serial/Telnet/SSH text console to CMC and log in.
2 Enable alerting by typing:
racadm config -g cfgAlerting -o cfgAlertingEnable 1
NOTE: Only one filter mask may be set by both SNMP and e-mail alerting.
You may skip step 3 if you have already set a filter mask.
3 Specify the events for which you want CMC to generate by typing:
racadm config -g cfgAlerting -o
cfgAlertingFilterMask <mask value>
where <mask value> is a hexadecimal value between 0x0 and 0xffffffff
and must be expressed with the leading
0x characters. Table 12-3 provides
filter masks for each event type. For instructions on calclulating the hex
value for the filter mask you want to enable, see step 3 on "Using
RACADM" on page 405.