Owner's Manual

394 I/O Fabric Management
DHCP Enabled Enables the IOM on the chassis to request and obtain an
IP address from the Dynamic Host Configuration Protocol (DHCP)
server automatically.
Default: Checked (enabled).
If this option is checked, the IOM retrieves IP configuration
(IP address, subnet mask, and gateway) automatically from a
DHCP server on your network.
NOTE: When this feature is enabled, the IP Address, Gateway,
and Subnet Mask property fields (located immediately adjacent
following this option) are inactivated, and any previously entered
values for these properties are ignored.
If this option is not checked, you must manually enter a valid
IP address, gateway, and subnet mask in the corresponding text
fields immediately following this option.
IP Address Specifies the IP address for the IOM network interface.
Subnet Mask Specifies the subnet mask for the IOM network interface.
Gateway Specifies the gateway for the IOM network interface.
Table 11-3. Configure I/O Module Network Settings
(continued)
Item Description