Owner's Manual

Using the iKVM Module 367
Setting or Changing the Password
To set or change the password:
1
Single-click and press <Enter> or double-click in the New field.
2 Type the new password in the New field and then press <Enter>.
Passwords are case sensitive and require 5–12 characters. They must
include at least one letter and one number. Legal characters are: A–Z, a–z,
0–9, space, and hyphen.
3 In the Repeat field, type the password again, and then press <Enter>.
4 Click OK if you only want to change your password, and then close the
dialog box.
Password-protecting Your Console
To password-protect your console:
1
Set your password as described in the previous procedure.
2 Select the Enable Screen Saver box.
3 Type the number of minutes of Inactivity Time (from 1 through 99) to
delay password protection and screen saver activation.
4 For Mode : If your monitor is ENERGY STAR compliant, select Energy ;
otherwise select
Screen .
NOTE: If the mode is set to Energy, the appliance puts the monitor into sleep
mode. This is normally indicated by the monitor powering off and the amber
light replacing the green power LED. If the mode is set to Screen, the OSCAR
flag bounces around the screen for the duration of the test. Before the test
starts, a warning popup box displays the following message: "Energy mode
may damage a monitor that is not ENERGY STAR compliant. However, once
started, the test can be quit immediately via mouse or keyboard interaction."
CAUTION: Monitor damage may result from the use of Energy mode with
monitors not compliant with Energy Star.
5 Optional: To activate the screen saver test, click Test . The Screen Saver
Test
dialog box displays. Click OK to start the test.
The test takes 10 seconds. When it concludes, you are returned to the
Security dialog box.