Owner's Manual

Using the CMC Directory Service 287
To specify an LDAP server, type:
racadm config -g cfgActiveDirectory -o
cfgADDomainController <AD domain controller IP
address>
To specify a Global Catalog server, type:
racadm config -g cfgActiveDirectory -o
cfgADGlobalCatalog <AD global catalog IP address>
NOTE: Setting the IP address as 0.0.0.0 disables CMC from searching
for a server.
NOTE: You can specify a list of LDAP or global catalog servers separated by
commas. CMC allows you to specify up to three IP addresses or host names.
NOTE: LDAP or LDAPs that are not correctly configured for all domains and
applications may produce unexpected results during the functioning of the
existing applications/domains.
2 Specify a DNS server using one of the following options:
• If DHCP is enabled on CMC and you want to use the DNS address
obtained automatically by the DHCP server, type the following command:
racadm config -g cfgLanNetworking -o
cfgDNSServersFromDHCP 1
• If DHCP is disabled on CMC, or if DHCP is enabled but you want to
specify your DNS IP address manually, type following commands:
racadm config -g cfgLanNetworking -o
cfgDNSServersFromDHCP 0
racadm config -g cfgLanNetworking -o
cfgDNSServer1
<primary DNS IP address>
racadm config -g cfgLanNetworking -o
cfgDNSServer2
<secondary DNS IP address>
The Extended Schema feature configuration is complete.