Owner's Manual

Using the CMC Web Interface 217
5 To save the selections click the Save QuickDeploy Settings button. If you
made changes to the iDRAC network setting, click the
Apply iDRAC
Network Settings
button to deploy the settings to the iDRAC.
6 To update the table to the last saved QuickDeploy settings, and restore the
iDRAC Network settings to the current values for each installed server,
click
Refresh .
NOTE: Clicking the Refresh button deletes all iDRAC QuickDeploy and iDRAC
Network configuration settings that have not been saved.
The QuickDeploy feature only executes when it is enabled, and a server is
inserted in the chassis. If Set iDRAC Root Password on Server Insertion and
QuickDeploy Enabled are checked, the user is prompted using the LCD
interface to allow or not allow the password change. If there are network
configuration settings that differ from the current iDRAC settings, the user is
prompted to either accept or not accept the changes.
NOTE: When there is a LAN or IPMI over LAN difference, the user is prompted to
accept the QuickDeploy IP address setting. If the difference is the DHCP setting,
the user is prompted to accept the DHCP QuickDeploy setting.
Enable iDRAC IPv6 Enables IPv6 addressing for each iDRAC present in the
chassis that is IPv6 capable.
Enable iDRAC IPv6
Autoconfiguration
Enables the iDRAC to obtain IPv6 settings (Address and
prefix length) from a DHCPv6 server and also enables
stateless address auto configuration. Default setting is
enabled.
iDRAC IPv6 Gateway Specifies the default IPv6 gateway to be assigned to the
iDRACs. Default setting is "::".
iDRAC IPv6 Prefix
Length
Specifies the prefix length to be assigned for the
IPv6 addresses on the iDRAC. Default setting is 64.
Table 5-59. QuickDeploy Settings
(continued)
Setting Description