Owner's Manual

216 Using the CMC Web Interface
Enable iDRAC LAN Enables/disables the iDRAC LAN channel.
Default: Unchecked (disabled)
Enable iDRAC IPv4 Enables/disables IPv4 on iDRAC. Default setting is
enabled.
Enable iDRAC IPMI
over LAN
Enables/disables the IPMI over LAN channel for each
iDRAC present in the chassis.
Default: Unchecked (disabled)
Enable iDRAC DHCP Enables/disables DHCP for each iDRAC present in the
chassis. If this option is enabled, the fields QuickDeploy IP,
QuickDeploy Subnet Mask, and QuickDeploy Gateway
are disabled, and can not be modified since DHCP is used
to automatically assign these settings for each iDRAC.
Default: Unchecked (disabled)
Starting iDRAC IPv4
Address (Slot 1)
Specifies the static IP address of the iDRAC of the server in
slot 1 of the enclosure. The IP address of each subsequent
iDRAC is incremented by 1 for each slot from slot 1's static
IP address. In the case where the IP address plus the slot
number is greater than the subnet mask, an error message is
displayed.
NOTE: The subnet mask and the gateway are not
incremented like the IP address.
For example, if the starting IP address is 192.168.0.250
and the subnet mask is 255.255.0.0 then the QuickDeploy
IP address for slot 15 is 192.168.0.265. If the subnet mask
were 255.255.255.0, the QuickDeploy IP address
range is not fully within QuickDeploy
Subnet error message is displayed when either the Save
QuickDeploy Settings or Auto-Populate Using
QuickDeploy Settings buttons are pressed.
iDRAC IPv4 Netmask Specifies the QuickDeploy subnet mask that is assigned to
all newly inserted servers.
iDRAC IPv4 Gateway Specifies the QuickDeploy default gateway that is assigned
to all iDRAC present in the chassis.
Table 5-59. QuickDeploy Settings
(continued)
Setting Description