Owner's Manual

Using the CMC Web Interface 115
The member chassis may not receive the message, if a network issue prevents
contact between the leader and the member. In this case, disable the member
from the member chassis to complete the removal. See the sub-section
“Disabling an Individual Member at the Member Chassis” for the procedure.
Disabling an Individual Member at the Member Chassis
Sometimes a member cannot be removed from a group by the lead chassis.
This can happen if network connectivity to the member is lost. A member can
be removed from a group at the member chassis by:
1
Login with chassis administrator privileges to the member chassis.
2 Click Setup  Group Administration .
3 Select None, and then click Apply .
Launching a Member Chassis’s or Server’s web page
Links to a member chassis’s web page, a server’s Remote Console or the
Server iDRAC’s web page within the group are available through the lead
chassis’s group page. Logging into the member device uses the user name and
password that was used to log into the lead Chassis. If the member device has
the same login credentials then no additional login is required. Otherwise, the
user is directed to the member device’s login page. To navigate to member
devices:
1
Login to the lead chassis.
2 Select Group: name in the tree.
3 If a member CMC is the required destination then select Launch CMC
below the desired chassis.
If a server in a chassis is the required destination then:
a Select the image of the destination chassis.
b In the chassis image that appears below the Health and Alerts pane,
select the server.
c In the box labeled Quick Links, select the destination device.
A new window is displayed with the destination page or login screen.