User's Manual

Using the RACADM Command Line Interface 77
If you do not know your user ID, try different values for n.
NOTE: The RACADM remote capability is supported only on management stations
through a supported browser. For more information, see the Supported Browsers
section in the
Dell Systems Software Support Matrix on the Dell Support website at
support.dell.com/manuals.
NOTE: When using the RACADM remote capability, you must have write
permissions on the folders where you are using the RACADM subcommands
involving file operations. For example:
racadm getconfig -f <file name> -r <IP address>
or
racadm sslcertupload -t 1 -f c:\cert\cert.txt
When using remote RACADM to capture the configuration groups into a file,
if a key property within a group is not set, the configuration group is not saved
as part of the configuration file. If these configuration groups are needed to
be cloned onto other CMCs, the key property must be set before executing
the getconfig -f command. Alternatively, you can manually enter the
missing properties into the configuration file after running the getconfig
-f command. This is true for all the racadm indexed groups.
This is the list of the indexed groups that exhibit this behavior and their
corresponding key properties:
cfgUserAdmin - cfgUserAdminUserName
cfgEmailAlert - cfgEmailAlertAddress
cfgTraps - cfgTrapsAlertDestIPAddr
cfgStandardSchema - cfgSSADRoleGroupName
cfgServerInfo - cfgServerBmcMacAddress
RACADM Error Messages
For information about RACADM CLI error messages, see "Troubleshooting"
on page 101.