User's Manual

Installing and Setting Up the CMC 43
• Blinking amber indicates that at least one component has a fault
condition.
• Blinking blue is an ID signal, used to identify one chassis in a
group of chassis.
Navigating in the LCD Screen
The right side of the LCD panel contains five buttons: four arrow buttons
(up, down, left, and right) and a center button.
• To move between screens , use the right (next) and left (previous) arrow
buttons. At any time while using the Configuration Wizard, you can
return to a previous screen.
•
To scroll through options on a screen , use the down and up arrow buttons.
•
To select and save an item on a screen and move to the next screen , use the
center button.
For more information about using the LCD panel, see the LCD panel section
in the Command Line Reference Guide for iDRAC6 and CMC.
Using the LCD Configuration Wizard
1 If you have not already done so, press the chassis power button to turn
it on.
The LCD screen displays a series of initialization screens as it powers up.
When it is ready, the
Language Setup screen displays.
2 Select your language using the arrow buttons, and then press the center
button to select the
Accept/Yes and press the center button again.
3 The Enclosure screen displays with the following question: Configure
Enclosure?
a Press the center button to continue to the CMC Network Settings
screen. See step 4.
b To exit the Configure Enclosure menu, select the NO icon and press
the center button. See step 9.