User's Manual

Troubleshooting and Recovery 385
You can configure up to four destinations to receive traps alerts. To add more
destination s, repeat steps 2–6.
NOTE: The commands in steps 2–6 overwrites any existing settings configured for
the index you specify (1–4). To determine whether an index has previously
configured values, type: racadm getconfig -g cfgTraps -i <
index >. If the index is
configured, values appear for the cfgTrapsAlertDestIPAddr and
cfgTrapsCommunityName objects.
To test an event trap for an alert destination, type:
racadm testtrap -i <index>
where <index> is a value 1–4 representing the alert destination you want to
test. If you are unsure of the index number, type:
racadm getconfig -g cfgTraps -i <index>
Configuring E-mail Alerts
When CMC detects a chassis event, such as an environmental warning or a
component failure, it can be configured to send an e-mail alert to one or more
e-mail addresses.
Table 12-2 provides an overview of the events that trigger e-mail and SNMP
alerts. For information on SNMP alerts, see "Configuring SNMP Alerts" on
page 379.
You can add and configure e-mail alerts using the Web interface or
RACADM.
Using the Web Interface
NOTE: To add or configure e-mail alerts, you must have Chassis Configuration
Administrator privilege.
1 Log in to the CMC Web interface.
2 Select Chassis in the system tree.
3 Click the Alerts tab. The Chassis Events page appears.
4 Enable alerting:
a Select the check boxes of the events for which you want to enable
alerting. To enable all events for alerting, select the
Select All check
box.
b Click Apply to save your settings.